16 November 2026

Affinity measurements in a single NMR tube, with a little help from fluorine

Ligand-detected NMR remains one of the most popular methods for identifying fragment binders. However, the approach is mostly used qualitatively, especially at the earliest stage of a project. It is possible to determine dissociation constants, but doing so normally requires preparing and analyzing a series of samples at different concentrations. Three years ago we highlighted an approach that could be run in a single NMR tube, but it required a concentration gradient throughout the tube, starting from high (millimolar) concentrations of ligand. A new open-access paper in Angew. Chem. Int. Ed. by Simon RĂ¼disser, Gabriela Stadler, and Alvar Gossert presents a potentially more general approach.
 
Chemical shift anisotropy KD (CSAKD) uses fluorine NMR, a subject we’ve discussed extensively. The “transverse relaxation rate” R2 of a 19F atom in a ligand can be measured experimentally and is a function of multiple parameters, some of which are intrinsic to the small molecule itself and some of which reflect interaction of the ligand with a protein. One contributor is the chemical shift anisotropy, or CSA, which varies depending on the electronic environment of the atom. Calculating the R2,CSA of a ligand and comparing it to the measured R2 can, in theory, allow one to determine the fraction of bound ligand. The  more ligand bound at a given concentration, of course, the higher the affinity.
 
The theory quickly gets complicated: the paper sports 11 equations (and 24 more in the supplementary information!) which include such esoteric terms as the “generalized order parameter,” “spectral densities,” and the “rhombicity of the diffusion tensor.” Fortunately, the “shape of the CSA tensor” can be calculated using density functional theory (DFT), though the calculations are onerous. In the new paper the researchers present a more efficient approach based on machine learning that speeds up the process by 7000-fold.
 
So, how well does it work in practice? The researchers used CSAKD to measure the affinities of one to three different known fluorine-containing ligands against four proteins, for a total of eight pairs, all of which had previously been characterized by NMR titration or isothermal titration calorimetry. The KD values determined from CSAKD ranged from 38 micromolar to 4.4 millimolar and were in good agreement with published numbers; several were within the margins of error and none differed by more than a factor of three. The researchers note that error bars are larger for more tightly-bound ligands.
 
Although I can’t claim to fully understand the theory, the approach does seem practical, and thus a worthy addition to the NMR toolbox. Pre-calculating the CSA tensors for a set of fluorine-containing ligands in a library would enable one not just to identify hits from an initial screening campaign, but to calculate their affinities from the outset. This will be the topic of my next post.

No comments: